Category Motors with controllers

Check out our new video and learn more about our latest motion synchronization solutions! The gearwheels are synchronized in a millisecond cycle via CANopen. The orange wheel...

Take an in-depth look at smart servo steppers and smart brushless servos. Our product comparison will help you understand the advantages of each technology so you can make an informed...

For setting up and programming its motor controllers, Nanotec offers the  Plug & Drive Studio. Setup is made easy thanks to several operating modes. The user can select and...

If communication is no longer possible with the motor controller or the motor after a failed firmware update, the firmware can be uploaded manually. Firmware update  for...

The CL3-E controller/drive has 5 V inputs. If a 24 V control signal is to be applied, it will require a 57 kOhm (0.25 W) resistor be connected in series to each input in...

The controllers  SMCI12, SCMI36  and  SCMP33  have 5 V inputs. If a 24 V control signal is to be applied, it will require a 39 kOhm (0.25 W) resistor be...

The motor controllers and motors with integrated controllers have open collector outputs. To switch a load or PLC, you require a relay according to this circuit diagram. The flyback diode...

Depending on the cable type, routing and length, an overcoupling onto the neighboring control line may occur with 24 V control signals. In motor controllers/drives with wide range inputs...

The Nanotec controllers and motors with integrated controller can be controlled by means of four different methods. DIP switches, configuration files, or software enable the user to select...