PD6-E/-EB Modbus TCP Online Manual

Overtemperature protection

Above a temperature of approx.  75°C on the power board (corresponds to 65–72°C outside on the back cover), the power part of the controller switches off and the error bit is set (see objects 1001h and 1003h). After cooling down and confirming the error (see table for the controlword, "Fault reset"), the controller again functions normally.

Temperature tests are performed under the following conditions:
  • Operating voltage / logic voltage: 48/24 V DC
  • Motor current: Rated current (see Electrical properties and technical data)
  • Operation mode: open-loop, velocity mode 100 rpm
  • Ambient temperature: 25 °C / 40 °C
  • Altitude of site: 500 m above sea level
  • No external cooling in the climatic chamber, e. g., via fan
  • Motor flange-mounted to aluminum plate (30 cm x 30 cm x 2 cm)
The following graphics show the results of the temperature tests:

At both 25 °C as well as at 40 °C, the motor was in operation for more than 3 hours without being switched off. The temperature reached its maximum after approx. 30 min. and then remained stable.

Note: Aside from the motor, the exact temperature behavior is also dependent on the flange connection and the heat transfer there as well as on the convection in the application. For this reason, we recommend always performing an endurance test in the actual environment for applications in which current level and ambient temperature pose a problem.
▶   next

Contents