NanoJ V2 Example Programs

NanoJ V2 Example Programs

This program is used to select the speed mode and switch on the "state machine". The motor starts automatically.
3 KB
The enable input is used to start the motor via the input rather than automatically.
4 KB
The analog input can be used to vary the speed.
4 KB
Depending on whether the motor runs at more or less than 200 rpm, the output is connected.
4 KB
Here the clock direction mode is selected, the "state machine" is switched on and the enable is connected.
3 KB
As above, yet with the additional settings for speed, scaling, filter and dead zone.
5 KB
In this mode, the motor moves between two positions that can be set via the 'VMM Input' objects.
8 KB
Following an automatic reference run, different run profiles are selected via the digital inputs and started.
11 KB
V1 - position mode is selected and started.
V2 - position mode is selected and started; the motor moves to a set position after the trigger signal.
V3 - position mode is selected and started; the motor moves to an analogously set position after the trigger signal.
16 KB
Back

Questions? Comments?

Do you have questions or remarks about this article?

Contact support