NP5 CANopen Online Manual

Commissioning the CANopen via the Discovery Board

To establish a connection with the NP5-08, proceed as follows:

  1. Plug in the NP5-08 at X8.
  2. Plug the jumper at X13.
  3. Set potentiometer P2 to 0 (counterclockwise as far as it will go)
  4. Switch on the termination resistor (Switch SW6 ON).
  5. Connect your CANopen cable to X2 an.
  6. Connect your supply voltage to X7.


Privacy settings
We use essential cookies that our website requires to function correctly. With your consent, we also use optional cookies for statistics and marketing. You can agree to the non‑essential cookies by clicking the "Accept" button or reject them. You can call up your settings and also withdraw your consent at any time. For more information, see our privacy statement.