Compact microstep positioning control for stepper motor to 1.4A

The extremely compact SMC11 microstep final output stage is a very simple and economic possibility for controlling stepper motors to 1.4 A phase current. With two corresponding boreholes, the printed circuit board with dimensions of only 36 x 36 mm is also ready for direct mounting on the rear side of a motor of the ST4118 and ST4209 series. (The B-version with 2 shaft ends is required for this as the boreholes are only in this version. The B-shaft must then be cut to length.) If you have any questions, please contact ourTechnical Hotline

Version with higher currents: SMC11GE- Preset: 1/16 step operation

Please note that not every NANOTEC stepper motor or linear actuator is PIN compatible to the motor socket on the SMC11.